A sump pump is a wise investment for protecting your basement or crawl space against damage from flooding. But if not installed right, a pump is going to mean big headaches in the form of no drainage, pump failure, and expensive repairs. We suggest hiring a professional expert for a successful sump pump installation in Toronto. Understanding what not to do during sump pump installation can be a game-changer. Let’s dig into this blog below to learn about common mistakes that must be avoided.

1.Choosing the Wrong Size Pump

One of the most common errors made is to purchase a sump pump that is either too powerful or too weak for your situation. An undersized pump may not be able to evacuate water during heavy rains, and an oversized pump can short-cycle and wear out prematurely. It’s a good idea to know how much water your sump pit usually collects and size a pump with enough horsepower and capacity.

2.Incorrect Pit Placement

The location of your sump pump matters. Make sure to put the sump pit in the lowest area, typically at the lowest point of your basement or crawl space. If you put your sump in one of the high spots of your basement or crawl space, the water will collect there. Be sure to place your pump on the lowest part of your space so water can be efficiently collected and routed out. It’s best to work with an expert for accurate and correct sump pump installation in Burlington.

3.Discharge Pipe Sized or Installed Improperly

Another common mistake is having too small or poorly placed discharge pipes. If the pipe is too small, it can limit the flow of water and cause your pump to work harder and shorten its life. Also, if you direct the line too close to the foundation the water can run back towards your house. If water is pushed further out from the foundation, at least 10-20 feet away would be best so that the same water is not simply cycled back in.

4.Lack of a Check Valve

One huge mistake during the sump pump installation in Toronto is not installing a check valve on the discharge line. A check valve keeps water from running back down the sump pit after it’s been pumped out. Without it, water in the system can feedback and turn the pump on and off, which not only wears down the pump but also can raise your water bill.

5.Poor Electrical Setup

Sump pumps must be connected to a GFCI (ground fault circuit interrupter) outlet in order to avoid electrical hazards. Running an extension cord or plugging the unit into an unsafe power source is a danger and may void your warranty or lead to the pump failing. You may also want to include a battery backup just in case you lose power during a storm — just when you need the pump the most.

Orella Group is your one-stop destination for proper sump pump installation in Toronto. We are here to protect your home from potential water damage, mold, and mildew growth. Book our services today.